zoncoffee_pid_controller
This is an old revision of the document!
Table of Contents
ZonCoffee PID Controller
ZonCoffee is an inexpensive PID controller built around the Atmel ATMEGA32u4.
Hardware Setup
- Connect your LCD
- Serial LCDs are connected to the “LCD” screw terminal
- Parallel LCDs are connected through the auxilliary connector
- Connect a rotary encoder
- Connect your solid-state relay
- Connect a buzzer (optional)
- Connect your power supply
Software Setup
Your ZonCoffee board comes pre-loaded with the latest firmware. However, you can flash your own custom firmware or updates using the Arduino bootloader which is pre-programmed on the ATMEGA32u4.
zoncoffee_pid_controller.1384133472.txt.gz · Last modified: 2023/03/23 02:48 (external edit)