protofusion

open hardware and software

User Tools

Site Tools


luma:products

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

luma:products [2013/12/01 04:40]
Ethan Zonca [Luma-1L-1.0]
luma:products [2019/06/13 02:48]
Line 1: Line 1:
-====== Luma Nodes ====== 
-Luma nodes are serially-addressable high-power RGBW lights. They are networked on a RS485 bus, so modules can easily be daisy-chained and controlled. 
  
- 
-===== Current Models ===== 
-==== Luma-1L-R4.1 ==== 
-{{:luma:luma4.1.jpg?600|}} 
- 
-Current model with onboard 1 10W RGBW LED and integrated heatsink. 
-==== Luma-3L-R4.1 [PRE-PRODUCTION] ==== 
-Current model with 3 onboard 10W RGBW LEDs and integrated heatsink. 
-==== Luma-S-4.0 [PRE-PRODUCTION] ==== 
-Current model for driving high-power RGB LED strips 
- 
-===== Obsolete Models ===== 
- 
-==== Luma-1L-4.0 ==== 
-Initial 10W RGBW LED model with RJ45 and screw terminal connectors mounted on the top of the board (current models have these components on the bottom). This model adds 4 constant-current buck drivers for each LED channel, an on-board led, an on-board heatsink, a temperature sensor, and a crystal for clocking at 16MHz. 
-==== Luma-1L-3.0 ==== 
-{{:luma:9nodes.jpg?600|}} 
- 
-Luma board with an off-board LED driven with discrete transistors and surface-mount current-limiting resistors. This model adds reverse voltage protection, a transistor-controlled fan output, and better heat dissipation for current-limiting resistors. 
-==== Luma-1L-2.0 ==== 
-The first Luma board to communicate over RS485. Uses current-limiting resistors and transistors to drive an off-board LED. 
-==== Luma-1L-1.0 ==== 
- 
-{{:luma:tinyrgb-bottom1.jpg?500|}} 
- 
-Intial Luma prototype, also known as TinyRGB. Communication over I2C using Cyz_RGB, an alternate firmware for BlinkM modules. 
luma/products.txt · Last modified: 2019/06/13 02:48 (external edit)